Set these in place, and use a piece of wood to tap them into place as the space between balusters is too small for a mallet or much manual dexterity. The bottom bracket covers are more rigid, with a tab at the post side. The top covers are flexible - just press and click them into place over the top of your bracket. You should hear the top cap click into place, but you can test it by pulling along both edges. Measure it, mark it, and cut it before you set it on top of the rail, align the ends, and tap it into place with your rubber mallet. The top cap – which goes over the top rail – has to be the same length as that rail. Step Four: Installing the Top Cap, Bracket Covers, and Post Caps Otherwise, you risk damaging the thread on your screws or the top rail and bracket. Remember to adjust your drill to a lower setting to insert the screws. Next, secure the top rail to the brackets on the railings at both ends with the provided stainless steel screws. Once they're sitting comfortably, use the windows you cut in the anti-rattle strip to drill two holes through the rail and the bracket. Next, line the ends of your railing up with the brackets on your posts and set them into place. Start this step by placing your anti-rattle adhesive strip on the top surfaces of your two bottom brackets. You'll have to backtrack later if you don't cut them now. This is to allow you to fasten your railing to your brackets and posts. Finally, you need to cut access holes in the anti-rattle strip at the top of your railing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |